How to remap the paddles?

Here’s your short guide to help you remap and set up the back paddles of PS5 and PS4 AIMController.

PlayStation 5 Controllers #

1. Plug the USB cable into the controller while plugged into your PS5 or PC.
2. Press & hold both (left and right) bottom paddles at the same time for 5 – 10 seconds to enter remap mode.
3. Press & hold the paddle and button that you would like it to correspond to for 2 – 3 seconds. (Example: press the bottom left paddle together with ‘X’ and hold for 2 seconds.)
4. Repeat step 3 for all the paddles.
5. Press & hold bottom two paddles for 6 – 10 seconds to exit remap mode.

Each button of the PS5 controller is able to be mapped to a paddle EXCEPT L2 & R2.
*Note there is no light or indication you are in remapping mode*

PlayStation 4 Controllers #

1. Plug in USB cable into controller.
2. Press & hold the Touchpad button for 5 seconds. After 5 seconds, the PS4 LED will begin to slowly blink – You may release the Touchpad button.
3. Press any of the buttons you want to re-map. The LED will blink indicating the button press was registered.
4. Press any of the paddles. LED will blink again indicating the re-mapping was successful.
5. If you want to continue re-mapping more buttons, go back to step 3; otherwise go to step 6.
6. Once you are done re-mapping, press the Touchpad button. The slow blink will stop.

   You can remap up to 12 buttons: X, Circle, Triangle, Square, Up (U),Down (D),Left (L),Right (R),L1,R1,Left Joy Stick Push Button (LJ),Right Joy Stick Push Button (RJ)